The failure of a slope certainly leads to big and undesired loss of life and property. Thus it is extremely important to check and analy...

The failure of a slope certainly leads to big and undesired loss of life and property. Thus it is extremely important to check and analyze the stability of proposed slopes. With the development of modern efficient techniques of testing of soils and stability analysis, a safe & economical design of slope can be successfully made. Hence, a geotechnical engineer efficiently should have through and reliant knowledge/ideas of all those existing accessible methods for checking the stability of slopes and their limitations.

Basis of slope failure analysis

The soil mass must be safe against slope failure on any conceivable surfaces across the slope. Even though the methods using the theory of elasticity or plasticity are also being increasingly used, the most common methods are based on limiting equilibrium in which it is assumed that the soil is at the verge of failure. The methods of limiting equilibrium are statically indeterminate. As the stress-strain relationships along the assumed surface are not known, it is necessary to make assumptions so that the system becomes statically determinate and it can be analyzed easily using the equilibrium equations.

The general assumptions to be made are as follows;

1. The stress system is assumed to be two-dimensional. The stresses in the third direction (perpendicular to the section of the soil mass) are taken as zero.

2. It is assumed that the coulomb equation for shear strength is applicable and the strength parameters c and phi* are known.

3. It is further assumed that the seepage conditions and water levels are known, and the corresponding pore water pressure can be estimated.

4. The conditions of plastic failure are assumed to be satisfied along the critical surface. In other words, shearing strain strains at all points of the critical surface are large enough to mobilize all the available shear strength.

5. Depending upon the method of analysis, some additional assumptions are made regarding magnitude and distribution of forces along various planes.

6. Thus, in the analysis the resultant of all the activating forces trying to source the failure is determined. Also the estimate of shear strength has to be made. For factor of safety, the available resisting forces and the actuating forces shall be used.

Name

ltr
item
strukts: Stability of slopes/slope failure
Stability of slopes/slope failure
http://4.bp.blogspot.com/-XZXhrPpYpwU/VRQ2LB0AAlI/AAAAAAAABV4/5ZapuA_RDME/s320/Con_model.gif
http://4.bp.blogspot.com/-XZXhrPpYpwU/VRQ2LB0AAlI/AAAAAAAABV4/5ZapuA_RDME/s72-c/Con_model.gif
strukts
http://www.strukts.com/2012/06/stability-of-slopesslope-failure_16.html
http://www.strukts.com/
http://www.strukts.com/
http://www.strukts.com/2012/06/stability-of-slopesslope-failure_16.html
true
7606260228666216043
UTF-8