A CONCRETE MIX is designed to produce concrete that can be easily placed at
the lowest cost. The concrete must be workable and
cohesive when plastic, then set and harden to give strong and durable
concrete. The mix design must consider the environment that
the concrete will be in; ie exposure to sea water, trucks, cars, forklifts, foot
traffic or extremes of hot and cold.PROPORTIONING Concrete is a mixture of Cement, Water, Coarse and Fine
Aggregates and Admixtures. The proportions of each material in the mixture
affects the properties of the final hardened concrete. These proportions are
best measured by weight. Measurement by volume is not as accurate, but is
suitable for minor projects.
CEMENT CONTENT As the cement content increases, so does strength and
durability. Therefore to increase the strength, increase
the cement content of a mix.
WATER CONTENT Adding MORE WATER to a mix gives a WEAKER hardened
concrete. Always use as little water as possible, only
enough to make the mix workable.
WATER TO CEMENT RATIO As the Water to Cement ratio INCREASES, the strength
and durability of hardened concrete DECREASES.
To increase the strength and durability of concrete, decrease the Water-Cement
AGGREGATES Too much fine aggregate gives a sticky mix.
Too much coarse aggregate gives a harsh or boney mix.
MIXING Concrete must be mixed so the Cement, Water, Aggregates and Admixtures
blend into an even mix. Concrete is normally mixed by MACHINE. Machine mixing
can be done on-site or be a Pre-Mixed concrete company. Pre-Mixed concrete is
(proportioned) at the plant to the job requirements.
Truck Mixing The materials are normally added to the trucks at batching plants
and mixed for required time and speed at the plant. The trucks drum continues to
rotate to agitate the concrete as it is delivered to the site.
Site Mixing When site mixing begin by loading a MEASURED AMOUNT of
coarse aggregate into the mixer drum. Add the sand before the cement, both in
measured amounts. NEVER USE A SHOVEL AS A MEASURE AS VOLUMES CAN VARY
WIDELY. Mix materials together until there is no visible sand in the mix. Add
enough water to get a workable mix.
Be careful not to overload the mixer. Too much concrete in the mixer means each
batch takes longer to be properly mixed, which causes costly delays in the long
run or it will not mix at all. Always check how much the mixer holds so you
know how much concrete can be produced at once. Avoid delays between batches to
get maximum output. Small quantities of concrete may be mixed by hand with
a shovel. Mixing should be done on a clean board, or plate, or in a wheelbarrow.
Mix the materials together until they are even. Then dish the material and add
water. Use only enough water to get an even, workable mix. Finish mixing.